Glue suggestions

[kerryin2004]

I figure this is relative since this guerrilla campaign is relative to it.. I have been using a stick glue (that I really don't like) to put up flyers, and I would like to know if any of you have suggestions on the type of glue to use ??

[NMDemDist2]

1. print the poster on full page "labels" from Avery (or office max)

then just peel and stick :-)

[kerryin2004]

2. No bueno senior..

I am going to get them made at kinkos:) I will just continue to use the glue stick, and hope the poster stays up!

[NMDemDist2]

3. get real good tape instead of a glue stick then n/t

[mopinko]

4. wall paper paste.

you can put some in a squeeze bottle.

[Cobalt Violet]

9. And once it is dry...

It is hard to get down. They would really have to work to pull them down.

[bahrbearian]

5. Spray 90 or some contact adhesive it takes a mintue to set up

but they will stay up nice, if you just spray the object your going to attach the flyer too , you can remove the flyer and change it to a new one.

[MaggieSwanson]

6. Go enviro-friendly...

A paste made of wheat flour and water is recommended in Ben Cohen's book "50 Ways to Show Bush the Door in 2004" - and I highly recommend the book as well!

[kerryin2004]

7. Thanks everyone

I am going back at it, I just hope I am not the only one doing this...

[gauguin57]

8. Using clear strapping (mail packing) tape should hold pretty well,

depending on where you're sticking it. When I go out with flyers, I take along a tote bag with strapping tape, a medium-sized stapler and a box of thumbtacks -- so I'm prepared for every surface I may have to put them up on.