HomeLatest ThreadsGreatest ThreadsForums & GroupsMy SubscriptionsMy Posts
DU Home » Latest Threads » Forums & Groups » Main » General Discussion (Forum) » Is it too early for a tal...

Sat May 16, 2020, 08:28 PM

Is it too early for a tally on viewer #'s for Obama's speech?

President Obama, that is

Am really curious. Bet it is millions+++

6 replies, 806 views

Reply to this thread

Back to top Alert abuse

Always highlight: 10 newest replies | Replies posted after I mark a forum
Replies to this discussion thread
Arrow 6 replies Author Time Post
Reply Is it too early for a tally on viewer #'s for Obama's speech? (Original post)
Budi May 2020 OP
Squinch May 2020 #1
sfstaxprep May 2020 #2
leftieNanner May 2020 #3
sfstaxprep May 2020 #6
LAS14 May 2020 #4
Budi May 2020 #5

Response to Budi (Original post)

Sat May 16, 2020, 08:30 PM

1. I bet it is, too. But we KNOW it is more people than the number that

has been killed by Donny Bodybags's refusal to do anything about CV19. So that's something.

Reply to this post

Back to top Alert abuse Link here Permalink


Response to Budi (Original post)

Sat May 16, 2020, 08:33 PM

2. Hasn't Aired On West Coast Yet

It's going to be on all the major networks(CBS, NBC, ABC, KTLA, KTTV) out here in CA starting at 8:00.

Reply to this post

Back to top Alert abuse Link here Permalink


Response to sfstaxprep (Reply #2)

Sat May 16, 2020, 08:46 PM

3. Yes it did.

MSNBC had it on. It's wonderful!

Reply to this post

Back to top Alert abuse Link here Permalink


Response to leftieNanner (Reply #3)

Sat May 16, 2020, 09:51 PM

6. Not Everyone Gets MSNBC

It's going to be on about 5 or 6 channels at 8:00 here in So Cal.

Reply to this post

Back to top Alert abuse Link here Permalink


Response to sfstaxprep (Reply #2)

Sat May 16, 2020, 08:47 PM

4. And Fox. Who'da thunk? nt

Reply to this post

Back to top Alert abuse Link here Permalink


Response to sfstaxprep (Reply #2)

Sat May 16, 2020, 08:54 PM

5. Thanks

Reply to this post

Back to top Alert abuse Link here Permalink

Reply to this thread